PPT Slide

Ideal Machining Parameters

• Please be Conservative (tool speeds very approximate)

• Cooling: always provide direct cooling from compressed air

Wet-Dry Bond

• Cutting Depths: Roughly Half Tool Diameter

• Feed Rates:

1. 500-750mmpm 1/8” or larger

2. 200-400mmpm 1/16”

Previous slide

Next slide

Back to first slide

View graphic version

Please Be Very Conservative, Tool Speeds Approximate. Try running at 60% of Feed Rate and then increasing.

Cooling - keep jets focused on cutter. Make sure nozzles are above substrate level to avoid collision

Safety Note: Adjust cooling jets with spindle not turning, do not reach in while machine is running!